Self Alignment Pipe Turnig Rolls Open Mouth Welding Rotate Tanks
Welding Rotator With Remote Control Box
1. The machine consists of 1 set of driving roller, 1 set of idler
roller and electric control system.
2. The drive roller and idle roll must be put the foundation in
same horizon. Two sets roller must be parallel to put, the ground
horizontal plane must even. If the long-term usage base needs to be
3. Ensure that there is ample space for movement of the equipment,
work piece as well as the operator.
4. The worm wheel decelerator of the machine adopts lubricating
oil, other gears and bearings adopt grease lubrication, periodic
change. Note: the lubricating oil isn't oiled into the machine at
shipping, the users must oil assigned lubricating oil, and then
begin to use.
5. Connect the 3-phase power supply only after all the mechanical
and electrical installations have completed. Ensure that the phases
are correct, if not the unit will not power up.
Description of self aligning welding rotator
1. It will adjust the tank diameters automatically.
2. Wireless control is more convenient than remote control cable.
3. Working range can be designed according to your tank diameter.
4. Low noise transmission and stable turning roller during working.
Delivery Package Range
1. One set powered / One set idler / Electric control system
2. Voltage : 380V 50Hz 3P
3. Control Way : Remote Control Box / Foot Pedal
4. Package Way : Wooden Case
5. Working Manual
|Model No.||Max loading||Motor power||Linear guide||Roller material|
Details Control system and Brand
1. Inverter is from Taida/Yaskawa Brand
2. Motor is from CE Invertek Brand
3. Reducer is from Cable. Made in China.
4. Electric system is from Schneider
Q: Can your machine or other products be customized?
A: yes,we are an professional manufacturer who specializes in
welding equipment about 15 years,
we have a strong design team ,so any conventional products can be
Q: What about the transportion?
A: Usually we take seaway ,cause its more convenient and cheaper
for big machine,of course ,
if it is allowed ,we also can take train ,its according to real
1. When finished installation, check whether tight firmware of each
port loosens to move the phenomenon or not, if have, please tighten
2. Before the usage check the machine and clear some bar the on
board ,the rubber roller can not get in touch with oil, and keep
off the heat possibly.These will prevent gum the gum roller to
3. We will supply you all the detail work manul for your reference.
DO NOT HESITATE ! JUST SEND US YOUR INQUIRY NOW.